Evertz Microsystems Ltd.

下载 PDF

7707MRA-HD

HD-SDI, 4 AES Audio, Bi-directional RS-232/422, 2 GPI/GPO Fiber Receiver

Dolby 合作伙伴

特点

  • Supports HD-SDI and SDI video
  • Demultiplexes up to 4 AES audio, bi-directional RS-232/422 and 2 GPIO with HD-SDI or SDI
  • Supports all SMPTE ST 292-1 (1.485Gb/s) rates/standards
  • Supports 525/625 line component 4:2:2 SDI @ 270Mb/s
  • Dolby E compatible
  • Built in jitter attenuation
  • Comprehensive signal and card status monitoring via four digit card edge display or remotely through SNMP and VistaLINK®
  • 当此模块与 7700FC VistaLINK® 主机控制器一起装在同一台 7800FR 主机上时，允许VistaLINK® 通过SNMP (使用VistaLINK® PRO) 进行远程监测与控制
    • Local display of optical signal strength, video, audio and data presence, video and AES formats, GPI and GPO status
    • Accepts any wavelength in the 1270nm to 1610nm range
    • Optical output wavelengths of 1310nm, 1550nm, and up to sixteen CWDM wavelengths (ITU-T G.694.2 compliant)
    • DWDM wavelengths (ITU-T G.694.1 compliant) also available
    • Supports single-mode and multi-mode fiber optic cable
    • Fully hot-swappable from front of frame
    • Occupies a single or dual card slot and can be housed in the 1RU 7801FR frame which holds up to four single or two dual slot modules, the 3RU 7800FR frame which has a 15 slot capacity, the portable 3RU 350FR frame which has a 7 slot capacity, or a standalone enclosure which holds a single module.

7707MRA-HD 应用配置

Fiber TypeFibersOptical Link BudgetTransmit SideReceive SideDescription
Ordering InformationTx PowerOrdering InformationRx Sensitivity
** : assumes 8Ch CWDM Mux/Demux loss of 3.5dB
*** : assumes 8Ch DWDM Mux/Demux loss of 5dB		 ~Tx Power/Rx Sensitivity are nominal values ±1dBm
~Fiber loss = 0.35/0.25dB per km @ 1310nm/1550nm
Multi-mode2< 1km7707MTA13-HD-F2-7dBm7707MRA13-HD-F2-23dBm1310nm on Tx & Rx fibers
Single-mode216dB/45km7707MTA13-HD-F2-7dBm7707MRA13-HD-F2-23dBm1310nm on Tx & Rx fibers
Single-mode1 (WDM)20dB/57km7707MTA15-HD-W-1dBm7707MRA13-HD-W-21dBm1310nm/1550nm WDM bi-directional, one fiber
Single-mode2 (CWDM)19dB/76km**7707MTAxx-HD-F20dBm7707MRAxx-HD-F2-23dBmDifferent CWDM wavelengths for Tx & Rx, with 8 channel CWDM Mux/Demux**
Single-mode2 (CWDM)24dB/96km**7707MTAxx-HD-F2-H0dBm7707MRAxx-HD-F2-H-28dBmDifferent CWDM wavelengths for Tx & Rx, with 8 channel CWDM Mux/Demux**
Single-mode2 (DWDM)30dB/120km***7707MTADxxx-HD-F2-H+7dBm7707MRADxxx-HD-F2-H-28dBmDifferent DWDM wavelengths for Tx & Rx, with 8 channel DWDM Mux/Demux***
产品结构图 产品结构图

指标

Optical Input/Output
Number of Connections1 or 2 (-F2 Versions)
端口数目Female SC/PC, ST/PC or FC/PC
反射损失> 14dB
上升/下降时间200ps nominal
Wide Band Jitter< 0.20 UI
光纤大小9µm core/125µm overall
Input Optical SensitivitySee Application Configurations Chart
工作波长
标准1310nm, 1550nm (nominal)
CWDM1270nm to 1610nm (see ordering information)
DWDMC-Band/L-Band (ITU-T G.694.1 compliant)
Output Power
1310nm FP-7dBm ±1dBm
CWDM0dBm ±1dBm
DWDM+7dBm ±1dBm
Serial Digital Video Outputs
输出数量2 regenerated
标准SMPTE ST 292-1 (HD-SDI), SMPTE ST 259-C (SD-SDI), SMPTE ST 305.2 (SDTi)
端口数目BNC per IEC 61169-8 Annex A
信号电平800mV nominal
直流偏置0V ±0.5V
上升/下降时间150ps nominal @ 1.485Gb/s, 600ps nominal @ 270Mb/s
过冲< 10% of amplitude
反射损失> 15dB up to 1.5Gb/s
Alignment Jitter< 0.2 UI
AES Audio Outputs
Number of Signals4 (user-selectable for balanced or unbalanced)
标准AES3-2003 (平衡 AES), SMPTE ST 276 (非平衡 AES)
端口数目Multi-pin Removable Terminal Block
信号电平
非平衡1V p-p ±0.1V Differential
平衡3.5V p-p ±0.1V
ResolutionUp to 24-bits
Sampling Rate48kHz
Rise/Fall Times
平衡20ns ±5ns
非平衡35ns ±5ns
反射损失> 15dB to 6MHz
频带抖动< 10ns p-p, with conditions of minimum to maximum cable length
Latency< 1ms @ 48kHz, < 1.2ms @ 32kHz
SRC Enabled< 6ms @ 48KHz, < 9ms @ 32KHz
SRC Disabled< 4ms @ 48KHz, < 6ms @ 32KHz
阻抗
非平衡75Ω
平衡110Ω
Serial Data
Number of Signals2 input/output
Connector at BreakoutMulti-pin Removable Terminal Block
Signal TypeRS-422, RS-232, or RS-485 (selectable)
Input TerminationHigh impedance
Input Failsafe Bias5KW to 5V on DI+ (selectable)
波特率Up to 153kb/s (selectable)
General Purpose Inputs
Number of Signals2 inputs
Connector at BreakoutMulti-pin Removable Terminal Block
TypeOpto-isolated, active low
Input Voltage
Safe Voltage Range-20V to +10V
Off Condition (min)+3.5V
On condition (max)+2.5V (active low)
Input Current (min)1mA
Input Current (max)10mA (internally limited)
General Purpose Outputs
输出数量2
Type"Dry Contact" relay closure
端口数目1 pin on 16-pin removable terminal block
信号电平Normally open
电气
电压+12V DC
功率9 瓦 (non-DWDm) or 12 瓦 (DWDM)
物理参数
插槽数
7707MRA13-HD-W1
-F2 versions2
标准
Laser SafetyClass 1 laser product
Complies with 24 CFR 1040.10 and 1040.11
IEC 60825-1
EMI/RFIComplies with FCC Part 15, Class A
EU EMC directive

订购信息

HD-SDI, 4 AES, Bi-directional RS-232/422, GPI/O Fiber Receiver
7707MRA13-HD-F2Dual fiber, 1310nm FP Tx & Rx
7707MRA13-HD-WSingle fiber, WDM, 1310nm FP Tx, 1550nm Rx (use with 7707MTA15-HD-W)
CWDM (订购信息)
7707MRAxx-HD-F2Dual fiber, CWDM Tx
7707MRAxx-HD-F2-HDual fiber, CWDM Tx, High sensitivity
DWDM (订购信息)
7707MRADxxx-HD-F2Dual fiber, DWDM Tx
7707MRADxxx-HD-F2-HDual fiber, DWDM Tx, High sensitivity
订购可选项
注意• +SCF connector option available for -W version only
• 后面板必须在下订单是指明 - eg: [model]+3RU
接头后缀
+SCSC/PC
+STST/PC
+FCFC/PC
+SCFSC/PC with flap cover
后面板后缀
+3RU3RU 后面板用于7800FR, 7801FR, 7700FR-C 或 350FR 多用途主机
+1RU1RU 后面板用于7701FR 多用途主机
+SA独立封装后面板
机箱
350FRPortable Multiframe which holds 7 modules
7700FR-C3RU 多用途主机，可装15 个模块
7800FR3RU 多用途主机，可装15 个模块
7701FR1RU 多用途主机，可装 3 个模块
S7701FR独立封装
光纤连接电缆
CB-FP1M-SCPC单模光纤, 1m, SC/PC 公头终接
CB-FP1M-STPC单模光纤, 1m, ST/PC 公头终接
CB-FP5M-SCPC单模光纤, 5m, SC/PC 公头终接
CB-FP5M-STPC单模光纤, 5m, ST/PC 公头终接
CB-FP10M-SCPC单模光纤, 10m, SC/PC 公头终接
CB-FP10M-STPC单模光纤, 10m, ST/PC 公头终接
About Us | Contact | Support © 2012 Evertz Microsystems, Ltd. All rights reserved webmaster@evertz.com