Evertz Microsystems Ltd.

下载 PDF

7707SVT-2

Dual S-Video Fiber Transmitter

VistaLINK® 兼容

The 7707SVT-2 is a VistaLINK® capable S-Video fiber transmitter for broadcast quality signals. This single card module accepts two S-Video inputs, performs analog to digital conversion and transmits them over a single fiber. The companion 7707SVR-2 S-Video Fiber Receiver demultiplexes the signals and converts them back to analog form.

The fiber output of the 7707SVT-2 is available in an assortment of optical wavelengths accomodating 1310nm/1550nm, CWDM and DWDM transmission schemes.

The 7707SVT-2 occupies one card slot and can be housed in the 1RU 7801FR frame which holds up to four single or two dual slot modules, the 3RU 7800FR frame which has a 15 slot capacity, the portable 3RU 350FR frame which has a 7 slot capacity, or a standalone enclosure which holds a single module.

特点
  • Single card fiber multiplexor for up to two S-Video signals
  • Supports both NTSC and PAL
  • Broadcast quality analog video performance
  • Meets or exceeds EIA/TIA RS250-C short haul specifications for analog video transport
  • Superior digital data transmission
  • Signal transport over fiber uninterrupted by loss of input video feeds
    • Comprehensive Signal and card status monitoring via four-digit card-edge display, or remotely through SNMP and VistaLINK® capability
    • Fully hot-swappable from front of frame with no fiber disconnect/reconnect required
    • Supports single mode and multi-mode fiber optic cable
    • Optical output wavelengths at 1310nm, 1550nm, and up to sixteen CWDM wavelengths (ITU-T G.694.2 compliant)
    • DWDM wavelengths (ITU-T G.694.1 compliant) also available
产品结构图 产品结构图

指标

Analog S-Video Input
标准NTSC, SMPTE ST 170, PAL, ITU-R 624-4
输入数量2
端口数目IEC 933-5 (4-pin mini-DIN)
Signal Quantization12 bits
System Bandwidth5.5MHz
Input LevelY: 1.0V p-p, C: 0.286V p-p
Input Impedance75Ω
反射损失> 30dB to 5.5MHz
Signal/Noise Ratio> 70dB
微分增益< 1.0%
微分相位< 0.7°
Passband Ripple
NTSC< ±0.1dB to 4.1MHz
< ±0.2dB to 5.5MHz
PAL< ±0.1dB to 4.8MHz
< ±0.2dB to 5.8MHz
Line Time Distortion1.2%
Optical Outputs
输出数量1
端口数目Female SC/PC, ST/PC or FC/PC
反射损失> 14dB
工作波长
标准1310nm, 1510nm (nominal)
CWDMSee Ordering Information
DWDMSee Ordering Information
Output Power
1310nm FP (Standard)-7dBm ±1dBm
1550 & CWDM DFB0dBm ±1dBm
DWDM7dBm ±1dBm
System Performance7707SVT-2 + 7707SVR-2
Video Input to Output Delay < 10µs
电气
电压+12V DC
功率11/12 瓦 (Non-DWDM), 13/14 瓦 (DWDM)
物理参数
插槽数1
标准
Laser SafetyClass 1 laser product
Complies with 24CFR 1040.10 and 1040.11 IEC 60825-1
EMI/RFIComplies with FCC Part 15 Class A, EU EMC Directive

订购信息

Dual S-Video Fiber Transmitter
7707SVT13-21310nm FP Laser, VistaLINK®
7707SVT15-21550nm DFB Laser, VistaLINK®
CWDM & DWDM (订购信息)
7707SVTxx-2CWDM DFB laser, VistaLINK® (订购信息)
7707SVTDxxx-2DWDM DFB laser, VistaLINK® (订购信息)
订购可选项
注意后面板和光纤接头必须在下订单时指明 - eg: [model]+SC+3RU
接头后缀
+SCSC/PC
+STST/PC
+FCFC/PC
后面板后缀
+3RU3RU 后面板用于7800FR, 7801FR, 7700FR-C 或 350FR 多用途主机
+1RU1RU 后面板用于7701FR 多用途主机
+SA独立封装后面板
机箱
350FRPortable Multiframe which holds 7 modules
7700FR-C3RU 多用途主机,可装15 个模块
7800FR3RU 多用途主机,可装15 个模块
7701FR1RU 多用途主机,可装 3 个模块
S7701FR独立封装
光纤连接电缆
CB-FP1M-SCPC单模光纤, 1m, SC/PC 公头终接
CB-FP1M-STPC单模光纤, 1m, ST/PC 公头终接
CB-FP5M-SCPC单模光纤, 5m, SC/PC 公头终接
CB-FP5M-STPC单模光纤, 5m, ST/PC 公头终接
CB-FP10M-SCPC单模光纤, 10m, SC/PC 公头终接
CB-FP10M-STPC单模光纤, 10m, ST/PC 公头终接
About Us | Contact | Support © 2012 Evertz Microsystems, Ltd. All rights reserved webmaster@evertz.com