Evertz Microsystems Ltd.

下载 PDF

7732DVP-HD

HD Dual Link Video Processor

VistaLINK® 兼容

The 7732DVP-HD Dual Link Video Processor module is a multi-purpose module designed to convert between 4:2:2 and 4:4:4 HDTV video signals in a wide variety of applications. The model 7732DVP-HD can be operated in a dual link to single link mode for 4:4:4 high definition applications, or 4:2:2 to 4:4:4 mode to convert traditional high definition content to 4:4:4.

The 7732DVP-HD occupies one card slot in the 3RU frame, which will hold up to 15 modules or the 1RU frame which will hold up to three modules.

特点

  • Automatically senses between 1080i/60, 1080i/50, 1080p/24sF, 720p/60 and 720p/50 video formats and the 1/1.001 divisor versions where applicable
  • 4:4:4 Dual Link HDSDI to 4:2:2 HDSDI converter
  • 4:2:2 HDSDI to 4:4:4 Dual link HDSDI converter
  • 4:4:4 Dual Link HDSDI to 4:4:4 HDSDI with LUTs
  • Two serial digital 1.5Gb/s HD inputs per ST 292-1
  • Three serial digital 1.5Gb/s HD outputs per ST 292-1
  • Bypass relay protection on inputs for power failures
  • Retimed 4:4:4 dual link outputs
  • Programmable LUTs for 4:4:4 and 4:2:2 HDSDI to accommodate different colorimetry between monitoring devices
  • Factory LUTs handle logarithmic "filmstream" inputs from VIPER and ARRI D20 cameras
  • Store / recall user presets of common configurations - up to 10 presets
    • 6 GPI control inputs to select operating modes or load user presets
    • 2 GPO status outputs indicate operating modes - programmable functions
    • Card edge menu using OSD on 4:2:2 output to configure the operating modes
    • Card edge LEDs for signal presence, module status
    • 当此模块与 7700FC VistaLINK® 主机控制器一起装在同一台 3RU 7800FR 主机中时，通过 SNMP (使用VistaLINK® PRO、 CP-2116E 或 CP-2232E 网络控制面板) 可得到 VistaLINK® 的远程控制与配置功能
产品结构图 产品结构图

指标

Serial Digital Video Input
标准SMPTE ST 372 (dual link 1.5Gb/s) or
ST 292-1 (1.5Gb/s) - auto-detects standard using SMPTE ST 352 Payload ID
SMPTE ST 274, SMPTE ST 296 - 1080i/60, 1080i/50, 1080p/24sF, 720p/60 and 720p/50 and the 1/1.001 divisor versions where applicable
SMPTE 428-9, ST 2048-2 - 2048x1080p/24sF
输入数量1 dual link or 1 single link
端口数目BNC per IEC 61169-8 Annex A
均衡Automatic to 65m @ 1.5Gb/s with Belden 1694 or equivalent cable
反射损失> -15dB up to 1.5GHz
Serial Digital Video Output
标准Same as input
Number of outputs2 dual link outputs (bypass relay protected to inputs) + 1 single link output
端口数目BNC per IEC 61169-8 Annex A
信号电平800mV nominal
直流偏置0V ±0.5V
上升/下降时间200ps nominal
过冲< 10% of amplitude
反射损失
4:4:4 Outputs> -10dB @ 1.5Gb/s
4:2:2 Output> -6dB @ 1.5Gb/s
抖动< 0.2UI
Payload IDSMPTE ST 352
GPIO Control Port
输入数量6, programmable functions
输出数量2, programmable functions
TypeOpto-isolated, active low with internal pull-ups to +5V or +12V (jumper selectable)
端口数目9-pin female D
信号电平Closure to ground
Look Up Tables
Type10 bit 1-D LUT
Number5 factory programmed
5 User loadable
User UploadRS-232, 57600 baud using card edge connector
Input to Output Processing DelayHD Input Video
Video Delay2 lines
电气
电压+12V DC
功率10 瓦
EMI/RFIComplies with FCC regulations for class A devices
Complies with EU EMC directive
物理参数
插槽数1

订购信息

7732DVP-HDHD Dual Link Video Processor
订购可选项
注意• 后面板必须在下订单是指明 - eg: [model]+3RU
后面板后缀
+3RU3RU 后面板用于7800FR, 7801FR, 7700FR-C 或 350FR 多用途主机
+1RU1RU 后面板用于7701FR 多用途主机
+SA独立封装后面板
机箱
350FRPortable Multiframe which holds 7 modules
7700FR-C3RU 多用途主机，可装15 个模块
7800FR3RU 多用途主机，可装15 个模块
7701FR1RU 多用途主机，可装 3 个模块
S7701FR独立封装
About Us | Contact | Support © 2012 Evertz Microsystems, Ltd. All rights reserved webmaster@evertz.com