*********************************************************
* This firmware is for the following products:          *
* ------------------------------------------------------*
* 3000MVP-VGO                                           *
*********************************************************

version 1.00 build 199  (November 22, 2012)
------------------------------------------
- -VGO now supports HDMI source and disable the SDI/DVI outputs when HDCP enabled in the PPMX. When HDCP is disabled in the PPMX, then SDI/DVI output are supported.

Version 1.03 build 195 (February 17, 2009)
------------------------------------------
- Improved SD-SDI jitter

Version 1.03 build 168 (March 27-08)
-----------------------------------------
- Correct Vertical stripes problem on output 2,3 and 4 with some cards on power cycle.

Version 1.03 build 163 (August 29-07)
-----------------------------------------
- Added support for new flash.

Version 1.03 build 160 (September 28, 2006)
-----------------------------------------
- Correct for timing differeneces in mfg build variations

Version 1.03 build 140 (May 05, 2006)
------------------------------------------
- correction to SDI output when switching between refresh rate
- correction to reports of card-edge toggle switch activity

Version 1.03 build 125 (March 28, 2006)
------------------------------------------
- added printouts to indicate toggle switch and DIP switch changes
- added status to the card-edge LEDs

Version 1.03 build 100 (March 01, 2006)
------------------------------------------
- increased frame buffer size to enable higher resolutions
- added support so the output locks to input
- decreased the delay
- reduced number of frame buffers
- added support for all resolutions with automatice cropping and centering of SDI outputs
- added ftp upgradeavility
- added glink outputs

Version 1.02 build 71 (January 16, 2006)
------------------------------------------
- Enable lasers for fiber-based Glinks

Version 1.02 build 66 (September 27, 2005)
------------------------------------------
- correction for Horizontal streaks on HD outputs 3/4

Version 1.02 build 39 (July 20, 2005)
-------------------------------------
- resolutions added:
          1400x1050@59.94
          1400x1050@50
          1920x1080@59.59
          1920x1080@50
          Barco XGA
          Barco SXGA
          Barco SXGA+

Version 1.02 build 34 (December 21, 2004)
-----------------------------------------
- addede support for 1600x1200 @ 59.94Hz DVI output

Version 1.00 build 568 (June 15, 2004)
--------------------------------------
- added support for 1600x1200 @ 50Hz
- fix for CRC error on HD-SDI output

** NOTE - This version of firmware requires the minimum version of the following components:

          3000MVP-PPMV/G v1.06 B1248
          Maestro 1.5.9

Version 1.00 build 445 (June 8, 2004)
-------------------------------------
- added support for 1366x768 resolution
- added support for SD-SDI 525i/59.94 and 625i/50
- added 50Hz support for all previous resolutions

** NOTE - This version of firmware requires the minimum version of the following components:

          3000MVP-PPMV/G v1.06 B1198
          Maestro 1.5.8 

Version 1.00 build 375 (March 05, 2004)
---------------------------------------
- added 'Glink input status' and 'errors detected' to monitor menu
- removed temperature readout from LED display
- swapped DVI outputs 1 and 2

Version 1.00 build 370 (February 25, 2004)
------------------------------------------
- resolved resolution output issues