********************************************************* * This firmware is for the following products: * * -------------------------------------------- * * 7710XUC-AES4-HD * ********************************************************* Version 1.07 build 105 (Nov 27, 2007) ----------------------------------------- - Added support for new Flash components. Version 1.06 build 105 (July 23, 2007) ----------------------------------------- - Correction to 625 deinterlacer configuration. - Added support for automatically switching video input sources between the PGM IN and PGM IN/OUT BNCs. - User must set the PGM IN/OUT BNC mode to input in order for this feature to work. - Implemented blanking of output video when input video standard changes (auto input video standard) or when missing video becomes present (non-auto input video standard). - Added support for no glitch mode. - Added support for FTP upgrades. - Frame rate menu item commits value on button push only. - Added support for fault traps Version 1.05 build 12 (May 03, 2006) ----------------------------------------- - correction made to closed captioning - correction to frozen video when changing frame rate with video source set to 'AUTO' Version 1.04 build 24 (April 10, 2006) ----------------------------------------- - correction to time code - correction to 608 to 708 translators in HD Version 1.03 build 1144 (February 20, 2006) ----------------------------------------- - added EIA608 and EIA708 present to the status window - added support for noise reducer - added support for time code - correction to audio delay in status window - correction to audio delay menu ballistics were to fast - audio pops with audio delay set to -100ms corrected - corrected the serial output slew rate as it was always set to SD on power up Version 1.01 build 390 (October 31, 2005) ----------------------------------------- - corrected issue when in 720p, if a 2 line help is displayed, the second line is not erased if the next help text contains only 1 line - Field counter in video output vertical interrupt should not change when video standard is progressive. There is only 1 "field" in progressive standards - improvement to prevent "flashing" of the status window - correction for line advance FS problem - audio delay is displayed in ms - correction for issue when DIP switches are active and a preset is recalled - New deinterlacer defaults - Added support for RGB clip and gamma adjust parameters - Corrections to menu strings - correction for issue with CC data on SD output - Corrections to the proc amp, gamma coeff - Default input video standard is "auto" - Force colour bars on when an HD to HD conversion is taking place - Removed support for 480p/59.94 - No need for 2 second timeout between input/output video standard change and auto recall preset - Added support for factory presets - increase minimum audio delay to prevent accidental underflow of the audio buffer - corrected ballistics on detail gain menu - correction to FPGA file decompression sometimes resulted in FPGA loader hanging - control system "load preset" and "store preset" commands have a "none" option - added read-only control system variable to retrieve the input video standard being used by the card - correction to LTC line number - deinterlacer is only on if: - Input video is SD - Input video is 1080i/59.94 or 1080i/50 and deinterlacer mode is frame - corrections for force minimum delay on sF and 24fps inputs - correction in Frame Sync that caused output image to be mixed between two frames - add 2:3 pull down support and time code support from 24PsF to 60P and 60i Version 1.00 build 778 (May 27, 2005) ------------------------------------- - full release