*********************************************************
* This firmware is for the following products:          *
* --------------------------------------------          *
* 7725VBI-K                                             *
*********************************************************

Version 1v03 build 43 - (July 12, 2005)
---------------------------------------
- added 100% and 75% full field colorbars as factory signals 25 and 26
- correction for not taking a key source from some of the later lines in field 2
- fix for lines 6 and 319 being blanked on the analog output in 625 mode
- added full field colorbars to factory test signal set in 525 mode
- selecting a test signal number that is out of range just gives a black line
- NTSC pedestal removed from vertical blanking lines

Version 1v02 build 36 - (October 06, 2003)
------------------------------------------
- fix for preset incompatiblity issue
- modules being upgraded from firmware versions 1v01 and older will loose any saved configurations

Version 1v02 build 19 - (September 10, 2003)
--------------------------------------------
- added multifield GCR factory test signal
- added keying onto lines 8 and 9 in field 1 as well as corresponding lines in field 2 in 525 mode

Version 1v0 build 96 - (May 22, 2002)
-------------------------------------
fixed the following issues: 
- factory test signals weren't being keyed properly (some of the test signals were repeated, and others were dropped)
- user line capture would initially display improper data until unit was power cycled
- line capture only allowed for 32 capture locations, this has been increased to 64 (manual states 64)

Version 1v0 build 83 - (May 7, 2002)
------------------------------------
- allows for data to be keyed onto output line numbers 10-32, 253-262, 273-295, 516-525 in 525 mode

Version 1v0 build 71 - (April 24, 2002)
---------------------------------------
- initial firmware release (525 support only)