*********************************************************
* This firmware is for the following products:          *
* --------------------------------------------          *
* 773DAC-HD                                             *
*********************************************************

Version 2.2 build 39 - (November 19, 2004)
------------------------------------------
- extended the range of video output so that signals below the blanking can be passed, specifically, the PLUGE signal
**NOTE - This change will only function on modules with hardware build 4 **  

Version 2.1 build 55 - (December 18, 2002)
------------------------------------------
- fix to reading of dip switch settings at boot-up

Version 2.1 build 12 - (August 25, 2000)
----------------------------------------
- improved boot-up sequence 

Version 2.1 build 1 - (August 18, 2000)
---------------------------------------
- support for dual-link video input mode, 4:4:4:4 (use DIP switch 6 to enable)
- new video output modes (RGB ext bi-sync, RGB ext tri-sync)
- dip switch meanings have changed, refer to manual version 1.4 for new assignments
+-----------------------------------------+
 DIP Switch  Function
+-----------------------------------------+
 1           Video Output signal select     
 2	
 3	
 4	
 5           Aspect Ratio Marker enable
 6           Dual-link input format enable
 7           Not used
 8           Not used
+------------------------------------------+


Version 2.0 build 180 - (July 18, 2000)
---------------------------------------
- final release
- enabled 4:3 markers
- fixes for problems locking to 720p
- fixes for 'disappearing sync' when switching between video modes.

Version 2.0 build 14 - (April 19, 2000)
---------------------------------------
- fixed auto lock to 59.94Hz
- monitor Alignment and Transient Edge Shapping are now done so that the entire production apeture is now visible on a SONY HDVS monitor

Version 1.0 build 14 - (March 31, 2000)
---------------------------------------
- initial release