********************************************************* * This firmware is for the following products: * * -------------------------------------------- * * X1201H-HES * ********************************************************* version 1.2 build 185 (January 24, 2012) -------------------------------------------- -Fixed HD switching in take and take black modes on ESS platforms version 1.2 build 181 (December 2, 2011) ---------------------------------------------- -Fixed SD switching in take and take black modes on non ESS platforms version 1.2 build 175 (November 8, 2011) ---------------------------------------------- -corrected intermittent green/black screen ocurring during a valid switch 1.2 b173 Changes: -- 720p/50 tri-level was not available as an option in the menu so it could not be used to reference a 720p/50 video signal 1.2 b166 Changes: -- A feature was added to allow the user to put the router into bypass mode using a GPI. 1.2 b92 Changes: -- individual SS control for Embedded audios. (Embedded Soft switch routers only). -- Added the STD. 2 mode for GPI's. -- BUG FIX for PAL, 720P, 1080P genlock for switch line and GPI control when using these standards. Also fixed issue with card switching on wrong line number. THis was happening because the unique pattern its looking for is not present (of board pulses per line) - Added a "none" option to the video reference menu (only for the non-softswitch version) - Added a "no tak*" option to the no video action menu (for all versions of the product) -- Added menu iten under utility menu to turn off error messages displayed on front panel. (Video Ref. Error, Dars Error e.t.c) -- Mutliple bindings for GPO's -- BUG FIX: When Panel is disconnected and than reconnected, software not refreshing the panels and due to that the panels might show wrong information sometimes. Now the software detects connect / disconnect of panels and refreshes the panel on connect. -- XPoint lock feature added. (user can lock xpoint change from differnt sources GPI's, remote port, local panel). -- Bug fix for GPO tally. (GPO was turned on when switching between inputs that were set in tally). -- Added a menu item under program gpi# for controlling Line sync (clean switch) -- Added Support for Quartz Protocol. 1.2 b78 Changes: -- For PAL card was looking at wrong number of broad pulses per line. Card looks for a unique pattern at beginning of each frame. If this pattern is found than it starts counting the line number from there. So if this pattern is not found card will never find correct line number to switch. This was happening for PAL video standard. 1.2 b72 Changes: -- Mutliple bindings for GPO's -- Individual SS control for audio -- When Panel is disconnected and than reconnected, software not refreshing the panels and due to that the panels might show wrong information sometimes. Now the software detects connect / disconnect of panels and refreshes the panel on connect. -- XPoint lock feature added. (user can lock xpoint change from differnt sources GPI's, remote port, local panel). -- Bug fix for GPO tally. (GPO was turned on when switching between inputs that were set in tally). -- Added menu under utility menus to allow user to turn off error messages that are displayed on the panel. Version 1.1 build 125 (March 10, 2003) -------------------------------------- - first official release ** NOTE: Units with a bypass relay installed should use X120**-BYP.bin firmware**