Interact with this product in a Layout Tool:
The 7807LT-2 is a dual fiber optic transmitter for RF signals in the extended L-Band or wider frequency range. It accepts two RF inputs from coaxial cable and provides two outputs for optical transmission. An RF monitor output is provided for each input, which offers a convenient means of obtaining peak satellite signal strength, or additional signal distribution. With two optical transmitters per single-slot card, the 7807LT-2 provides a high density economical solution.
Individual monitoring and control is provided for each signal path. Gain may be adjusted manually or managed automatically via AGC. With SmartMON™, incoming RF signal strength, LNB current and other data are relayed over the fiber outputs for monitoring at the receiver side through SNMP/VistaLINK® (requires SmartMON™ capable companion fiber receiver). 13/18V DC selectable LNB power with 22kHz tone is also provided on each RF input.
特点
- Extended frequency response for extended L-Band, off-air DTV and other signals
- Protocol independent design - transports all modulation formats
- LNB power with selectable 13/18V DC, per input
- LNB current limit and short circuit protection
- LNB current monitoring for advance warning of LNB failure
- 22kHz tone on/off for LNB local oscillator control, per input
- RF monitoring output ports for signal peaking and signal distribution
- Manual gain and AGC modes for tuning optimal CNR performance
- Multiple versions of the 7807LT-2 are available to address single-mode/ multi-mode fiber, single/dual fiber and CWDM/DWDM applications
- The 7807LT13/15-2-W is a dual channel card that features an on-board fiber coupler, requiring only a single fiber for the link (companion receiver is the 7807LR-2-W)
- Dual fiber transmitters on a single-slot card provides the industry's highest density solution
- SmartMON™ capability provides remote status monitoring via SNMP without a separate data connection
- VistaLINK® capability is available for monitoring and control when modules are used in a 3RU 7800FR frame and a 7700FC VistaLINK® frame controller is installed in slot 1 of the frame
- Form-C dry contact GPO alarm contacts for monitoring
- Fiber link provides electrical isolation between antenna and facility, mitigating ground loop and lightning issues
- Compatible with all 2406LR, 7706LR, 7708LR and 7807LR-2 series receivers
- The 7807LT-2 occupies one card slot and can be housed in the 1RU 7801FR frame which holds up to four single or two dual slot modules, the 3RU 7800FR frame which has a 15 slot capacity, the portable 3RU 350FR frame which has a 7 slot capacity, or a standalone enclosure which holds a single module.
指标|
RF Input | |
---|---|
输入数量 | 2 |
Connectors | BNC per IEC 61169-8 Annex A (F-Type optional) |
Input Impedance | 75Ω |
反射损失 | > 14dB to 2100MHz > 10dB to 2100MHz to 2800MHz |
Frequency Range | 50 – 2800MHz |
Input Power Range | -10dBm to -60dBm |
AGC Gain Range | -10dB to +20dB |
Input IP3 | +10dBm |
LNB Power | |
---|---|
电压 | 13V DC, 18V DC, off (selectable) |
Current | 500mA |
Protection | Short circuit, current limited |
LO Control | 22kHz on/off (selectable) |
RF Monitor Output | |
---|---|
输出数量 | 2 |
端口数目 | BNC per IEC 61169-8 Annex A (F-Type optional) |
Output Impedance | 75Ω |
反射损失 | > 15dB |
Frequency Range | 50 – 2800MHz |
Output Level | within -2.0dB of input signal |
光输出 | |
---|---|
输出数量 | 2 |
端口数目 | Female SC/UPC, FC/UPC, SC/APC, FC/APC |
Operating Wavelength | 1310nm DFB (1550nm and CWDM optional) DWDM C-Band (ITU G.694.1 compliant) |
Output Power | |
Dual Fiber | +2dBm ±1dBm |
Single Fiber | -2dBm ±1dBm |
DWDM | +11dBm |
RF System Performance7807LT-2 + 7807LR-2 pair | |
---|---|
Flatness | |
850 – 2250MHz | ±1.5dB |
50 – 2800MHz | ±2dB |
General Purpose Outputs | |
---|---|
输出数量 | 2 |
Type | "Dry Contact" relay contacts - normally open and normally closed contact provided |
端口数目 | 3-pin terminal strip |
电气 | |
---|---|
电压 | 12V DC |
功率 | 6 watts excluding LNB power |
物理参数 | |
---|---|
插槽数 | 1 |
标准 | |
---|---|
Laser Safety | Class 1 laser product Complies with 24 CFR 1040.10 and 1040.11 IEC 60825-1 |
EMI/RFI | Complies with FCC regulations for Class A devices. Complies with EU EMC directive 89/336/EEC |
订购信息|
注意 | • Cards are physically compatible with the 7700FR-C frame, but LNB power will be automatically disabled. |
---|---|
• For companion receiver see the 7807LR-2 catalog page. | |
• Also compatible with the 2406LR, 7706LR and 7708LRA/7708LR-H receivers. |
7807LT13-2 | Dual L-Band RF Fiber Transmitter, 1310nm DFB laser, SmartMON™, VistaLINK® |
---|---|
7807LT13/15-2-W | Dual L-Band/Wideband RF Fiber Transmitter, 1310nm & 1550 DFB laser, onboard coupler with single fiber output, SmartMON™, VistaLINK®; companion receiver is the 7807LR-2-W |
CWDM & DWDM (Ordering Information) | |
---|---|
7807LTxx/yy-2 | Dual L-Band/Wideband RF Fiber Transmitter, CWDM, DFB Laser, SmartMON™, VistaLINK® |
7807LTDxxx/yyy-2 | Dual RF Fiber Transmitter, wideband, with SmartMON™ and VistaLINK®, high power ±10dBm DWDM DFB Laser, 75Ω BNC |
订购可选项 | |
---|---|
注意 | • Rear plate and fiber connector must be specified at time of order - eg: [model]+SC+3RU |
• 75Ω BNC Connectors are standard. | |
• Consult factory for 500Ω BNC and SMA connector options. |
Connector Suffix | |
---|---|
+SC | SC/PC |
+AP+SC | SC/APC (Angle Polished) |
+FC | FC/PC |
+AP+FC | FC/APC (Angle Polished) |
+F75 | 75Ω F-Type |
Rear Plate Suffix | |
---|---|
+1RU | 1RU rear plate for use with 7701FR Multiframe |
+SA | Standalone Enclosure Rear Plate |
+3RU | 3RU rear plate for use with 7800FR Multiframes |
Enclosures | |
---|---|
7800FR | 3RU Multiframe which holds 15 single slot modules |
7701FR | 1RU Multiframe which holds 3 single slot modules |
S7701FR | 7700 Series Standalone Enclosure |